Maintenance of the Best Anilox roller in china

The Best Anilox roller in china is the heart component of flexographic printing machine, which has a crucial impact on the printing effect. When purchasing printing equipment, the selection and configuration of the Best Anilox roller in china is important, but if the maintenance measures are improper, the service life of anilox roller will be greatly reduced. The daily maintenance of the Best Anilox roller in china shall meet the following requirements:

1. Do not scratch, touch or bump the Best Anilox roller in china

(1) Keep the equipment clean. In addition to keeping the environment around the equipment clean, it is also important to keep the equipment clean, especially the protective cover, to prevent the ink residue in the protective cover from falling between the anilox roll and the rubber roll;

(2) Use clean ink. After using ink for a period of time, for various reasons, it may contain impurities or sand particles, or some ink itself may contain impurities or sand particles. Therefore, before the ink is put on the machine, it is best to filter it with a filter screen of more than 100 mesh, and add a magnet at the ink inlet pipe of the ink supply system;

(3) Ensure that the wiping cloth is clean. This is a problem that is easy to be neglected. After wiping the plate, the operators of printing machines in many packaging factories throw the plate wiping cloth on the floor, which is easy to adhere the sand on the floor to the plate wiping cloth and bring the plate to the anilox roller, resulting in the scratch of the anilox roller;

(4) Pay attention to the quality of base paper. There are a lot of impurities on the surface of the base paper, and the ink is sticky. When the printing plate comes into contact with the paperboard with the ink, the impurities on the surface of the base paper may also be taken away and transferred to the Best Anilox roller in china, causing damage to the anilox roller, especially some impurities with large particles;

(5) When replacing or cleaning the the Best Anilox roller in china, it is forbidden to impact the Best Anilox roller in china, and care should be taken. If the the Best Anilox roller in china is impacted, the net hole will be damaged and the printing effect will be affected; The whole anilox roller shall be scrapped if it is heavy.

2. Clean the Best Anilox roller in china

(1) Do the daily cleaning of the Best Anilox roller in china. After working for a whole day, there is still a lot of ink at the bottom of the mesh hole of the anilox roller. If the ink in the mesh hole is not cleaned in time, it will be very difficult to clean it again when the ink dries up at the bottom of the mesh hole. To thoroughly clean the ink in the net hole, we need enough cleaning time to clean it with copper brush or steel brush and washing machine water.

(2) Thoroughly clean the Best Anilox roller in china regularly. Even if the daily cleaning of anilox roller is done well, it is still inevitable that ink remains at the bottom of the mesh hole and dries up. This phenomenon can be clearly seen under a high-power magnifying glass. Therefore, the the Best Anilox roller in china must be thoroughly cleaned regularly, such as using special cleaning solution, ultrasonic cleaning method, low-pressure jet cleaning method, dry ice cleaning method, chemical solvent immersion method, etc.